AE Amplifiers/Preamplifiers: KRN Services

The KRN AMP-xxBB-J series of wideband preamplifiers are designed to interface the KRNBB-PC sensor to your Digital Acquisition System or to AE Test System for signal capture and analysis.

The AMP-xxBB-Jx line provides power and a DC bias point to the current amplifier (jfet) integral to the KRNBB-PC sensor. Currently this preamplifier is available in 4 different configurations to suit your lab or AE test equipment needs.

The AMP-4BB-J & AMP-12BB-J preamplifiers come equipped with an internal universal 28 Volt DC power supply, or they can be powered from an external DC power source via a (switched) BNC connector mounted on the back panel. The AMP-4BB-J28 preamplifier is only powered from an external DC supply while the AMP-1BB-J preamplifier is powered from an AE Test System. For all models the user can select one of two different gain modes for operation. The “Cal Mode” provides -0.92 dB (x0.9)of preamplifier gain while “Test Mode” provides 27dB (35 dB for AMP-1BB-J) of gain over a broad spectrum of frequencies. Each preamplifier channel can be individually set to Cal or Test mode.

Contact ATG for more information ([email protected])

AMP-1BB-J

Single channel broadband preamplifier

AMP-1BB-AE

Single channel broadband preamplifier

AMP-12BB-J

Twelve channel broadband with integral power supply

AMP-4BB-J

Four channel broadband with integral power supply

KRNBB

Single channel broadband with external power supply

AMPBB-Jx

Single channel broadband with tuned pulse circuit

KRNBB-P150

Single channel broadband with 150 kHz with tuned pulse circuit

AMP-4BB-J28

Four channel with external power supply

krn_0KRN Services, Inc. was founded in 1991 and designs and manufactures Acoustic Emission (AE) sensors used by test companies, manufacturing firms, electrical utility, DOT, and academia.

Contact ATG

    Your name:

    Your email:

    Subject:

    Your message: